From Supercomputación y Cálculo Científico UIS
Revision as of 16:04, 9 April 2015 by Ltorres (talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)


Procedure to add a new LDAP server to phpldapadmin

Several procedures associated with phpldapadmin

To add a new LDAP server to phpldapadmin the file config.php must be modified. In a default debian setup it should be found on: /etc/phpldapadmin/config.php Normally, config.php is generated from an example file included with the installation: /usr/share/phpldapadmin/config/config.php.example For the procedure to include the first ldap server in a phpldapadmin setup please refer to and the comments inside the example file. To add a new server go to the end of the file config.php, where there is a section with the following header (around line number 500):

File: /etc/phpldapadmin/config.php
  * If you want to configure additional LDAP servers, do so below.         *
  * Remove the commented lines and use this section as a template for all  *
  * your other LDAP servers.                                               *

Each server template comes with all the instructions required to set it up commented. e.g:

File: /etc/phpldapadmin/config.php
$servers->setValue('server','name','LDAP Server');

1. It's mandatory that each server definition starts with a call to newServer. What this means is that all the setup lines of a given server must appear after a line like '$servers->newServer('ldap_pla');', and of course before a similar line.

2. The 'name' clausule in '$servers->setValue('server','name','LDAP Server');' is a familiar, human readable, name, that will appear in the site to identify the server. An example could be "new ldap server" or "myldap".

3. The 'base' clausule represents the descriptors (dc) required to identify the server instance to manage. The dc are stored in the array of the third parameter. E.g: 'array('dc=uis,dc=edu,dc=co')'.

4. Only one type of login and authentication is selected in '$servers->setValue('login','auth_type','cookie');' (in this case cookies). The example file should be checked to see all options available.

5. In the clausule '$servers->setValue('login','bind_id',);' the distinguished name of the admin or some privileged user must set as the third parameter.

--- These are the options to be set to configure a new ldap server to be managed by phpldapadmin. There are advaced options not covered in this instructions that can be accessed in the comments of the example file in the installation or in the documentation found in phpldapadmin documentation.